Financing Available!

Whole House Generator Installation & Repair in Manchester, NH

REQUEST A QUOTE

TESTIMONIALS

What Our Clients Are Saying About Us

Whole house generator installation in Manchester, NH, keeps your lights, heat, and water running when the grid goes down. LHR Plumbing and Heating sizes, installs, and repairs standby generators so your family is never left cold and dark during a New England storm. Schedule your generator consultation today and get an upfront quote.

What a Whole House Generator Does For Your Home

A whole house generator is a permanently installed standby unit that monitors your electrical service and takes over within seconds of an outage. Unlike a portable unit, it starts on its own, with no extension cords and no trip outside in freezing rain.

Manchester winters put real pressure on the grid. Ice-loaded lines, nor’easters, and high winds take out power for hours or days, and a home without electricity quickly loses heat, hot water, and the ability to run a sump pump or well pump.

A properly sized standby generator keeps those systems on. Your heating system keeps cycling, the refrigerator stays cold, and pipes in an unheated basement stay above freezing while the rest of the neighborhood waits on the utility.

Choosing The Right Generator Size and Fuel Type

Sizing starts with what you want running during an outage. Some homeowners back up essential circuits only, covering the heating system, well pump, refrigerator, and a few lights, while others want the entire house to run as though nothing happened.

Fuel type matters just as much. Natural gas draws from your existing gas line and never needs refilling, while propane suits homes without gas service and stores on site in a tank sized for extended runtime.

Our technicians walk the home, review the electrical panel capacity, and calculate the actual load before recommending a unit. That calculation is the foundation of every whole-house generator installation in Manchester, NH, and it is what separates a system that carries your home comfortably from one that strains every time the well pump kicks on.

How Our Generator Installation Works, Start To Finish

Every installation follows the same sequence, so you know what is happening at each stage.

  1.       Load assessment. A technician reviews your panel, fuel supply, and the circuits you want backed up.
  2.       System selection. Our team recommends a generator size and fuel type, then provides upfront pricing before any work begins.
  3.       Site preparation. Pad location, fuel routing, and transfer switch placement are set for safe clearance and service access.
  4.       Installation and connection. Certified technicians set the unit, tie in the fuel supply, and wire the automatic transfer switch to your panel.
  5.       Startup and testing. The generator is commissioned, run under load, and set to perform its weekly self-test.

You get a walkthrough of the controls before the crew leaves, so operating the system is second nature long before the first outage.

Warning Signs Your Standby Generator Needs Service

A standby generator sits idle most of the year, which is exactly why problems go unnoticed until the power actually drops. Watch for these signs between outages.

  •       Failed or skipped weekly self-test
  •       Hard starting or extended cranking
  •       Delayed transfer during outages
  •       Visible corrosion or fuel leaks
  •       Warning codes on the controller

Any of these point to a generator that will not carry your home when it counts. Contact LHR Plumbing and Heating for a diagnostic before the next storm rolls through.

Generator Problems Our Techs Repair Most Often

Most whole house generator repair calls trace back to a handful of failure points. Dead or weak batteries top the list, since the battery cranks the engine and degrades quietly through New England winters.

Fuel delivery is the next common culprit. Clogged filters, stale fuel, and regulator faults leave an engine that cranks but will not run, and gas pressure problems often surface only under full load.

Automatic transfer switch failures make up the third group. When the switch does not sense the outage or will not transfer cleanly, the generator can run perfectly while the house stays dark.

Control board errors, oil and coolant leaks, worn plugs, and corroded connections round out the list. Our technicians diagnose the actual fault rather than swapping parts, then explain the repair and the cost before proceeding.

Emergency Generator Repair During Outages

An outage is the worst time to discover a generator will not start. LHR Plumbing and Heating is open 24/7, so around-the-clock emergency service is available when your standby system fails in the middle of a storm.

Technicians arrive equipped to diagnose starting failures, transfer switch faults, and fuel supply problems on site. When a part is required, you get upfront pricing before the repair moves forward.

Do not wait out a January outage hoping the unit resets itself. Whole house generator repair in Manchester, NH, is available around the clock, so contact us and get a technician working the problem.

Generator Pricing And Expectations

The cost of whole house generator installation and repair comes down to a few concrete factors. Generator size, fuel type, the distance from the unit to your panel and fuel supply, and whether your electrical panel can carry the new load all move the number.

Repairs work the same way. A battery replacement and a transfer switch rebuild sit at opposite ends of the range, which is why our team quotes the specific job after the diagnostic instead of over the phone.

Every estimate comes with upfront pricing before work starts. Financing plans are available for full generator installations, and our membership plans cover ongoing maintenance for homeowners who want the system checked on a schedule.

Why Homeowners In Manchester Trust LHR Plumbing And Heating

Choosing a contractor for a system this important comes down to availability, honesty, and follow-through.

  •       Around-the-clock emergency service
  •       Upfront pricing before work begins
  •       Certified technicians and backed warranties
  •       Same-day service and fast scheduling
  •       Financing on qualifying installations

Every job is backed by a satisfaction guarantee, and the same licensed Manchester team handles your plumbing, heating, and cooling. Schedule your whole house generator installation or repair in Manchester, NH, today.

Frequently Asked Questions About Whole House Generators

How much does whole house generator installation cost in Manchester, NH?

Cost depends on generator size, fuel type, and the electrical and fuel work your home needs. LHR Plumbing and Heating provides upfront pricing after assessing the site, and financing plans are available on qualifying installations.

Yes. LHR Plumbing and Heating is open 24/7, so emergency generator repair is available nights, weekends, and holidays. Contact us when your standby system fails during an outage and a technician is dispatched.

Scheduling is quick, and same-day service is available for many calls. Reach out to book a load assessment, and our team will confirm the installation date once the generator and materials are selected.

Yes. Repairs are performed by certified technicians and backed by warranty, and every job carries our satisfaction guarantee. Ask your technician for the specific coverage that applies to your generator.

Installation covers load assessment, generator sizing, pad and fuel connections, transfer switch wiring, and startup testing. Repair covers diagnostics and the fix, from batteries and fuel components to transfer switches and control boards.

SERVICE AREAS

Other Heating Services in Bedford and Nearby Areas